CMTS

CMTS module allows provision of the Internet via TV cables and makes easier the process of installation of end-client´s devices.
After purchasing the module, you will co-operate with our technical support on its implementation. They will make all the necessary settings of your network and network devices.

 

Supported versions of DOCSIS

ISPadmin supports all currently used DOCSIS versions 1.0, 1.1, 2.0, 3.0.

 

Supported headends

ISPadmin currently supports the following headends (the list is subject to future updates): Arris 1xxx, Arris C3, Arris C4, CISCO UBR10K, CISCO UBR71xx, CISCO UBR72xx, Motorola BSR1000, Motorola BSR2000, CASA, Juniper G1, miniCMTS

 

System Settings

 

CMTS Hardware

When you purchase the CMTS module, you will see a new menu Hardware CMTS in your ISPadmin. Through this menu, you will be able to add modems and amplifiers (headends), and to display retrieved information about hardware used and frequencies (Hardware CMTS Hardware, Hardware CMTS Frequency). Information is retrieved via SNMP from cable modems, so there is no need to retrieve it from routers.

 

Adding headends/amplifiers

If you have added routers into your system, you need to add headends (Hardware Routers All, Add headend), and then amplifiers to them (Hardware CMTS Amplifiers).


Adding CMTS services

Then you can add CMTS services to clients in the Client card > Active services. Information on both, statistics of the service and the possibility to restart a modem will be displayed in the Client card > Internet statistic, Cable modem section.


Filtering CMTS clients and routers

In Clients Internet, you´ll have a Service type filter with CMTS. You can also filter clients with CMTS services in Hardware CMTS Detail (Click on name to get to the Client card.)

Also, you can use filter State > With CMTS in HardwareRoutersAll and display routers with connected CMTS.

CONTACT

NET service solution, s.r.o.
Žerotínova 3056/81a
787 01 Šumperk
Czech Republic