×

Warning

JUser: :_load: Unable to load user with ID: 43

Reverse charge

 

In some countries, it is possible to use the so-called reverse charge mode for specific services (for example, cable installation). When you generate invoices manually, it is possible to set this mode for each individual item. In such a case, e.g. 21% VAT rate appears on a given invoice, but the VAT amount is 0 EUR.

To be able to use this function, you have to set the reverse_charge key to 1 in InvoicingSettingsGeneral. If it is active, you can check the reverse charge box for each item on an individual invoice. The invoice is then issued in the reverse charge mode. You can set the note that will appear on a reverse charge invoice in the reverse_charge_note key in InvoicingSettingsGeneral.
While adding/editing any service, you may select to Invoice separately each/any of them. Reverse-charge invoice will be issued separately.

 

In the overview of reverse charge invoices on this page, you can find the following information:

 

  • Client
  • VAT No.
  • Date of taxable transactions
  • Note
  • VAT base

 

You can filter here according to year, month, invoice type and invoice group.

 

icon lupa Show a given reverse charge invoice
Show detail of the Invoice If you check this box, further information about invoices will be displayed.

Mikrotik guide

This document approximates crucial information necessary for proper understan...

Removing records from ISPadmin

Delete client Deleted client is not deleted from the system, instead its rec...

Download burst

http://wiki.mikrotik.com/wiki/Manual:Queues_-_Burst (http://wiki.mikrotik....

Binary backups of MikroTik routers not working

The most common error messages regarding binary backups are: Mikrotik E...

Add / Edit Router

HardwareRoutersAll, + Add new router or Edit in the details box of a particul...

Limited data consumed / Traffic graphs are high

If you experience one/both of the following problems Limited data gets consum...

Router connection test

Hardware Routers All Click on Update all routers (test connection to all router...

Router monitoring

If router is monitored, the system does not copy any configurations, it barely p...

Service activation on MikroTik routers

An active communication between router and ISPadmin is a prerequisite for its...

Installation Modems

There are two different ways of adding cable TV clients to the system: A new ...

User rights to access MikroTik router

Also, to ensure correct communication between a router and ISPadmin you have ...

Can the system monitor latency and packet loss rate for each device?

Yes, all devices (including client devices, if you want) are monitored and gr...

How to set up a UBNT router

1. Define the IP address range for clients on the router where shaping is don...

Under what conditions does the WiFi Clients at AP section appear in the overview of routers?

Set up a particular device as an access point and specify where shaping is ...

Supported routers and interfaces

Router SNMP SSH API IPv6 Wlan MAC filter Firewall MAC filter Firewa...

Creating ACCESS LIST

In a situation where the router Mikrotik is only an AP without any routed networ...

Retrieving routing table from MikroTik routers

If there are more than 1,000 rows in the routing table on a Mikrotik router, ...

How to mass delete clients' MAC addresses

You can see the following icon - MAC FILTER - in the header of a router with the...

«
»

CONTACT

NET service solution, s.r.o.
Žerotínova 3056/81a
787 01 Šumperk
Czech Republic